Introduction: JIC Fitting is a range of hydraulic fittings which is produced in accordance to the SAE J514 requirements. The acronym JIC stands for Joint Industry Council. It is likewise known as the JIC thirty seven degrees flare fitting as it has a 37 degrees flare seating surface. These fittings are utilized on oil hydraulic systems in fields that are numerous (gas delivery, fuel power program, shipbuilding, mobile hydraulic equipment, etc...). A JIC fitting system has 3 components which create a tubing assembly: fitting, flare nut, and sleeve.
Material: Materials used-to fabricate JIC fittings are carbon steel as well as stainless-steel SS316L.
Sizes: JIC body and flare nut are obtainable in outer diameter ("OD) sizes between 1/8" to one 2". Sleeve has two specific reading measurements, metric measurement (mm) & inch outer diameter ("OD). Sleeve size is available from 3mm to 50mm as well as 1/8" to 2". Connecting sizes are designated by the corresponding outside diameter of the tubing for the various types of tube ends.
Working Pressure: The typical functioning strain of the fittings ranges from 1000 to 5000 psi for various sizes and connections. The minimum burst pressure is four times the working pressure. The JIC fittings must be ready to withstand twice the working stress for a period of 1 minute with no leakage or failure. Please take note that the pressure rating of an exact same fitting may vary when it is connected to different equipments.. For example, if a fitting with a reduced performing pressure is linked to a pipe, it is going to result in an overall even lower functioning strain. In all cases, constantly think about the lowest pressure as the highest working pressure of the product.
How does a JIC fitting works: For tube connections, the assembly treatment starts off from the preparation of the hose. For starters, the nut as well as sleeve are inserted onto the end of a hose. With all the usage of a flaring tool, form the end of the hose to thirty seven degrees. Then, tighten the nut by using a spanner until the nut is tight and also the sleeve grips onto the tube. If the fittings are bench assembled, the gripping measures can be driven by revolving the tube manually as the nut is pulled down. When the tube can easily no longer be driven by hand, the sleeve has gripped onto the tube. When this occurs,, tighten the nut by turning it one complete turn. This might vary somewhat with some other tubing materials, but reviews for alpilean (blogospherenews.com said in a blog post) common practice, it is a good rule to follow.
Configurations of JIC Fitting: Commonly utilized connection types be made up of: JIC/BSPP Male Connector, JIC/ NPT Male connector, JIC union, JIC/NPT Swivel Male Connector, JIC/BSPP Swivel Male Connector.
Brand of JIC Fittings: HS Corporation is a Korean manufacturer specializing in JIC Fitting. Established in 1980, HS Corporation has more than 30 years of specialized experience in manufacturing fittings.
Introduction To JIC Fittings
Introduction:
